Multitech CDMA Betriebsanweisung PDF herunterladen (Seite 124)

MULTISOCKET AT COMMA

NDS

AT Commands for EV-DO-EV3 Modems

124

Multisocket AT Commands

Note: For UIP devices, commands in this section apply only if the UIP stack is disabled (AT+WOPEN=0).

Socket Status #SS

Execute command reports the current status of the socket in the format:

#SS: <connID>,<state>,<locIP>,<locPort>,<remIP>,<remPort>

[<CR><LF><connID>,<state>,<locIP>,<locPort>,<remIP>,<remPort>[…]]

where:

<connID> Socket connection identifier.

1-6

The response format is:

#SS: <connID>,<state>,<locIP>,<locPort>,<remIP>,<remPort>

where:

<connID> Socket connection identifier.

<state> Actual state of the socket.

0 Socket closed.

1 Socket with an active data transfer connection.

2 Socket suspended.

3 Socket suspended with pending data.

4 Socket listening.

5 Socket with an incoming connection. Waiting for the user accept or shutdown command.

<locIP> IP address associated by the context activation to the socket.

<locPort> If the socket is placed in listen mode, the listening port.

If the socket is used to connect to a remote machine, the local port for the connection.

<remIP> When connected to a remote machine, this is the remote IP address.

<remPort> The port connected to on the remote machine.

Test command reports the OK result code.

Syntax

Command Command type

AT#SS Execute

AT#SS=? Test

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 248 249

Keine Kommentare

Multitech CDMA Betriebsanweisung Seite 124