Multitech MultiConnect Adapter Betriebsanweisung PDF herunterladen (Seite 106)

Chapter 10 – SMTP Client

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 106

Scenario 3 – Sending a Text Email Using

Configuration and Interactive Mode

This scenario sends a text email with:

• The to-addresses, cc-addresses, and subject taken from the configuration and

• The message body is entered in interactive mode.

To support this scenario, you must configure the following details in addition to the mandatory configuration

• Set subject data of maximum length 255 characters.

Command: set send-mail subject subject data

• Set to-addresses of maximum length 64 characters.

Command: set send-mail to-address 1 <email-id #1>

set send-mail to-address 2 <email-Id#2>

• Set cc-addresses of maximum length 64 characters.

Command: set send-mail cc-address 1 <email-ID#3>

set send-mail cc-address 2 <email-ID#4>

Issue the following command at the serial command prompt: #send-mail

The SMTP session then enters into interactive mode and requests that the message body be entered as shown in

the figure below. After completing the message, type Ctrl+D to end the message.

The email is sent only to the recipients who are pre-configured. The subject is also taken from the configuration.

Notes

1. The email is sent to addresses pre-configured using set commands.

2. At least one address, either the to-address or the cc-address, should be configured using set commands;

otherwise, the SMTP session enters into interactive mode prompting you to enter the required details.

3. If the subject option is not specified or is not pre-configured using set commands, SNMP enters into

interactive mode and requests a subject to be entered.

4. Type Ctrl+C to quit the email at any given time.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 153 154

Keine Kommentare

Modele	Rodzaj dokumentu
SC-USB	Podręcznik Użytkownika Campbell SC-USB User guide, 26 strony
SC-USB	Instrukcja Obsługi Campbell SC-USB Product manual, 36 strony
KH20	Instrukcja Obsługi Campbell KH20 Instruction manual [en] , 48 strony
SDM-CD16D	Podręcznik Użytkownika Campbell SDM-CD16D User guide, 17 strony
CS505	Instrukcja Użytkownika Model CS205 10-Hour Fuel Temperature Stick [en] , 10 strony
25458	Instrukcja Użytkownika 25458 DIN-Rail Terminal Kit [en] [it] , 10 strony
CS210	Instrukcja Użytkownika CS210 Manual - Campbell Scientific, 14 strony
TX312	Instrukcja Użytkownika Snotel Goes Manual R2b, 10 strony
SDM-CD16D	Dokumentacja Campbell SDM-CD16D Specifications, 20 strony
TDR	Instrukcja Użytkownika Comparison of laboratory TDR soil water measurements, 16 strony
CompactFlash CFM100	Instrukcja Obsługi Campbell CompactFlash CFM100 Instruction manual, 32 strony
SC932C 9-Pin	Podręcznik Użytkownika Campbell SC932C 9-Pin User guide, 16 strony
CompactFlash CFM100	Instrukcja Obsługi Campbell CompactFlash CFM100 Product manual [en] , 28 strony
CS525	Instrukcja Użytkownika CS525 - Campbell Scientific, 2 strony
TX320	Instrukcja Użytkownika La Désirade et Deshaies : choix technologiques et - Refmar, 14 strony
RTMS SYSTEMS	Instrukcja Obsługi Campbell RTMS SYSTEMS Instruction manual, 58 strony
RWIS STATIONS	Instrukcja Użytkownika Flood, Road, and Weather Data in Colorado, 2 strony

Multitech MultiConnect Adapter Betriebsanweisung Seite 106