Multitech MTPSR1-202ST Betriebsanweisung PDF herunterladen (Seite 82)

ProxyServer User Guide

MTPSR1-202ST

* In Windows 95, if the “Use Country Code and Area Code” box is checked in the Properties window for dial-up connec-

tion, the bundling modifier (i.e., &, + or !) is removed from the dialing string when the user attempts to make a connection.

The solution is to not check the “Use Country Code and Area Code” box, or to simply add the bundling dial modifier to the

phone number at the time of connection.

Canceling a Call

To cancel a call before the ProxyServer makes a connection, press any key.

Storing a Telephone Number

To store a telephone number, type

&Zn=x

in terminal mode, where

is the number of the memory

is the dial command string that you want to store.

For example, type AT&Z9=612-785-3500 <CR> to store the number 612-785-3500 in memory

Dialing a Stored Telephone Number

To dial a stored telephone number, type

&DS=n

in terminal mode, where

is the location of the

number you wish to dial. For example, type ATDS=3 <CR> dials a telephone stored in memory

Displaying a Stored Number

To display a stored telephone number, type

&Zn?

in terminal mode, where

is the memory register

in which the number is stored. For example, type AT&Z5? <CR> to display the telephone number in

memory register 5. To list all ten telephone numbers stored in memory, type ATL <CR>.

Answering a Call

You can answer incoming calls to the ProxyServer either manually or automatically. When the

ProxyServer detects an incoming call, it turns on the RI signal on the V.24 interface, and sends a

RING

result code to the computer or terminal after each ring. If autoanswer is enabled, the ProxySer-

ver will automatically answer the call. You can also manually answer the call by using the

com-

mand. Both methods are described below.

Answering Manually

If your communication program is in terminal mode when the

RING

result code appears on your

monitor, you can manually answer the call by typing

ATA <CR>

Answering Automatically

To cause the ProxyServer to automatically answer a call:

1. Enable autoanswer by setting register

to the ring on which you want the ProxyServer to

answer (e.g., in terminal mode, type

S0=4

to make the ProxyServer answer on the fourth ring).

You can also use either of the configuration utilities to the turn autoanswer on and set the number

of rings.

2. Make sure that the ProxyServer is offline.

The ProxyServer will answer the call after the number of rings specified by

. To disable

autoanswer, use a configuration utility or the command

S0=0

*: If the user wishes to accept calls while DTR is low, the ProxyServer must be configured to ignore

DTR. This is accomplished by entering AT&D0<cr>. With this configuration, the ProxyServer is able

to accept calls while DTR is low. If this configuration setting is not made, the TA rejects incoming

calls until DTR is high while the calls comes in.

Hanging Up

To hang up a call, first escape to online command mode (

+++AT<CR>

), then enter the

command

(

ATH<CR>

). The escape sequence and hang up command can be combined into one command

string:

+++ATH<CR>

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 103 104

Kommentare zu diesen Handbüchern

Keine Kommentare

Multitech MTPSR1-202ST Betriebsanweisung Seite 82

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Multitech MTPSR1-202ST