Multitech RF650VPN Bedienungsanleitung PDF herunterladen (Seite 44)

FriendlyNET VPN Security Router

•

Remote IP Network: 192.168.123.0

•

Remote IP Netmask: 255.255.255.0

•

Remote Gateway IP: 172.16.0.123

•

Network Interface: WAN ETHERNET

4.2 Client-to-Network

To connect a remote client PC to your network, use one of the fol-

lowing configurations based on the type of IP address of the client:

Mode 1— Dynamic IP Address

The remote PC obtains a dynamic IP address, and the user has to

setup the IPSec Client software (i.e. SSH). In this case, you must

configure the router with the following:

•

Remote IP Network: 0.0.0.0

•

Remote IP Netmask: 0.0.0.0

•

Remote Gateway IP: 0.0.0.0

•

Network Interface: The interface on the router used to

communicate with the remote network. Most users should

leave this set to WAN ETHERNET

•

Local IPSEC Identifier: Allows you to identify multiple tun-

nels and does not have to match the name used at the

other end of the tunnel. This field may remain blank. The

default value is Local.

•

Remote IPSEC Identifier: Allows you to identify multiple

tunnels and does not have to match the name used at the

other end of the tunnel. This field may remain blank. The

default value is Remote.

Note: If you need to use Manual Mode (as described in

section 4.4), you must enter valid addresses in all the

fields, as they cannot be 0.0.0.0.

Mode 2—Static (fixed) IP Address

The remote PC obtains a fixed IP address, and the user must setup

the IPSec Client software (i.e. VPNCOM) that will act as a virtual

NIC card (the PC will appear to the router as a virtual NIC card). In

this case, you must configure the router with the following:

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

Multitech RF650VPN Bedienungsanleitung Seite 44

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Multitech RF650VPN