Multitech ISIHP-4U Spezifikationen PDF herunterladen (Seite 14)

14 CommPlete 4000 Communications Server Quick Start Guide

Installing Your CommPlete 4000

SBC Board Cabling

The SBC board is located in the CommPlete 4000 as shown in Figure 2-1. The SBC board cabling may

involve connection to three back panel connectors (see Figure 2-2). The back panel connectors are:

 Video connector

 COM 1 connector

 Keyboard connector

SBC

Backplane

6-Pin Circular Jack

(To External Keyboard)

DB9 (male) Connector

(to COM 1 Serial Port)

15-Pin Video

Connector

(to External

Display Monitor)

120

100M

LINK

ACT

Fig. 2-2. SBC Backplane Connections

The right connector (COM 1) on the SBCs backplane typically accommodates a mouse or other

pointing device. The middle receptacle connects the video cable to a monitor. The left round

connector is for the keyboard.

Note: Any cables connected to the CommPlete 4000 should be shielded to reduce interference.

ISI Board Cabling

Each Intelligent Serial Interface card (ISI5634PCI/8, ISI4608PCI, or ISIHP-2S/2U) takes up one physical

slot in the CommPlete 4000. Depending on your configuration, you may have as many as four of these

cards (see Figure 2-1). Attach the line cords (RJ-12 for analog phone lines; RJ-45 for ISDN phone

lines) to the line connectors on the ISI card(s) at the back of your CommPlete 4000 as shown in Figure

2-3.

ISI5634PCI/8 Board

120

100M

LINK

ACT

RJ12 Line Jacks

Figure 2-3: ISI Board Connectors (ISI5634PCI/8 shown; other MultiModem ISI cards differ)

Note: Any cables connected to the CommPlete 4000 should be shielded to reduce interference.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Keine Kommentare

Multitech ISIHP-4U Spezifikationen Seite 14