Multitech MTCMR-G2 Betriebsanweisung

MultiModem®iCellMTCMR User Guide

SAFETY NOTICES AND WARNINGS UL evaluated this device for use in ordinary locations only. UL did NOT evaluate this device for installation ina vehicle

LEDS, CONNECTORS, AND SPECIFICATIONSLEDs, Connectors, and SpecificationsFrontMTCMR-E1, -G2, -H5 MTCMR-C1, -C2, -EV2, -EV3LEDsLED DescriptionTD Transmi

LEDS, CONNECTORS, AND SPECIFICATIONSLED DescriptionOFF indicates device is OFF indicates device is turned Flashing at 75 ms on/ 75 ms off/75turned off

LEDS, CONNECTORS, AND SPECIFICATIONSMTCMR-H5 SpecificationsCategory DescriptionGeneralPerformance HSPA+Frequency Bands Penta band 850/900/1700/1900/21

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionRadio Compliance FCC Part 22FCC Part 24RSS 132RSS 133EN 301 511EN 301 489-1EN 301 489-3 (GPS m

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionPower 2.5mm miniature (screw-on)USB Type BEnvironmentOperating Temperature -22° to 185° F (-30

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionDimensions 3.1 in x 4.9 in x 1.1 in (7.9 cm x 12.4 cm x 2.8 cm)ConnectorsCellular 50 ohm SMA (

LEDS, CONNECTORS, AND SPECIFICATIONSMTCMR-G2 SpecificationsCategory DescriptionGeneralPerformance GPRS: Class 10Frequency Bands Quad-band GSM/GPRS/EDG

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionRadio Compliance FCC Part 22FCC Part 24RSS 132RSS 133EN 301 511EN 301 489-1EN 301 489-3 (GPS m

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionPower 2.5mm miniature (screw-on)USB Type BEnvironmentOperating Temperature -40° to 185° F (-40

MULTIMODEM® ICELL USER GUIDEMultiModem®iCell User GuideModels: MTCMR-E1, -C1, -C2 -G2, -H5, -EV2, -EV3, optional -GP buildsPart Number: S000484, Versi

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionDimensions 3.1 in x 4.9 in x 1.1 in (7.9 cm x 12.4 cm x 2.8 cm)ConnectorsCellular 50 ohm SMA (

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionPacket Data EDGE: E-GPRS Up to 240K bps, coding scheme MCS 1-9, mobile station Class B, LLC la

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionRadio Compliance FCC Part 22FCC Part 24RSS 132RSS 133EN 301 511EN 301 489-1EN 301 489-3 (GPS m

LEDS, CONNECTORS, AND SPECIFICATIONSPower MeasurementsMulti-Tech Systems, Inc. recommends that you incorporate a 10% buffer into your power source whe

LEDS, CONNECTORS, AND SPECIFICATIONSMTCMR-H5-GPGSM 850Idle Typical Maximum Peak TX In-rush Current9 voltsCurrent (AMPS) 0.097 0.125 0.225 1.32 1.63Wat

LEDS, CONNECTORS, AND SPECIFICATIONSTypical Maximum Peak TX In-rush CurrentCurrent (AMPS) 0.045 0.107 0.176 1.70Watts 1.44 3.42EV-DOTypical Maximum Pe

LEDS, CONNECTORS, AND SPECIFICATIONSTypical Maximum Peak TX In-rush CurrentCurrent (AMPS) 0.084 0.158 0.232 1.86Watts 1.68 3.1632 voltsCurrent (AMPS)

LEDS, CONNECTORS, AND SPECIFICATIONSMTCMR-EV2CDMA 2000Sleep Typical Maximum9 voltsCurrent (AMPS) 0.119 0.220 0.560Watts 1.10 2.02 5.0920 voltsCurrent

LEDS, CONNECTORS, AND SPECIFICATIONSMTCMR-G2Sleep Typical Maximum Peak TX9 voltsCurrent (AMPS) 0.069 0.109 0.194 1.53Watts 0.640 1.010 1.79020 voltsCu

LEDS, CONNECTORS, AND SPECIFICATIONSSleep Typical MaximumWatts 0.67 1.47 3.68MTCMR-C1-GPSleep Typical Maximum9 voltsCurrent (AMPS) 0.096 0.175 0.435Wa

CONTENTSContentsProduct Overview ...

LEDS, CONNECTORS, AND SPECIFICATIONSMTCMR-C2-GPIdle Typical Maximum Peak InrushCurrent9 voltsPCS (1900 MHz) Curren 0.119 0.158 0.448 0.488 2.09t(AMPS)

LEDS, CONNECTORS, AND SPECIFICATIONSSleep Typical Maximum Peak TX20 voltsCurrent (AMPS) 0.051 0.080 0.190 0.890Watts 1.02 1.60 3.8032 voltsCurrent (AM

LEDS, CONNECTORS, AND SPECIFICATIONS3G Antenna Requirements/SpecificationsCategory DescriptionFrequency Range 824 – 960 MHz / 1710 – 1990 MHz / 1920 –

LEDS, CONNECTORS, AND SPECIFICATIONSGSM/EGSM Antenna Requirements/SpecificationsCategory DescriptionFrequency Range 824—960 MHz / 1710—1990 MHzImpedan

LEDS, CONNECTORS, AND SPECIFICATIONSCategory DescriptionInterface UARTProtocol NMEA-0183 V3.01, GGA, GLL, GSA, GSV, RMC, VTGUnderwriters Laboratories,

LEDS, CONNECTORS, AND SPECIFICATIONSGPIOGPIO CableGPIO ConnectorUse Universal IP (UIP) AT Commands to configure GPIO pins. Refer to the Universal IP (

LEDS, CONNECTORS, AND SPECIFICATIONS Configure Pin 4 as either Digital Input (5V tolerant TTL/CMOS levels), Digital Output (3.3V High) or as an ADCin

LEDS, CONNECTORS, AND SPECIFICATIONSPin Abbre Description In/Outviation3 TX Transmit I4 DTR Data Terminal Ready I5 GND Ground --6 DSR Data Set Ready O

DEVICE ACTIVATION AND INSTALLATIONDevice Activation and InstallationAccount Activation for Cellular DevicesSome Multi-Tech cellular modems are pre-con

DEVICE ACTIVATION AND INSTALLATION3. Insert the SIM card into the card holder with the contact side facing down as shown.4. Verify that the SIM card f

CONTENTSMTCMR-C2 ...

DEVICE ACTIVATION AND INSTALLATION1. Remove the power supply cover (not shown). To do this, slide the lock down and hold it while you lift offthe cove

DEVICE ACTIVATION AND INSTALLATION Verify the location has a strong signal strength. Position the device so the antenna is always vertical and point

DEVICE ACTIVATION AND INSTALLATION8. Click Have Disk.9. Browse to the Drivers folder.10. Select MTSMCIP_MTCMRIP.INF and click Open.11. Select your dev

BASIC OPERATIONSBasic OperationsDevice Phone NumberEvery device has a unique phone number. Your service provider supplies a phone number when you acti

BASIC OPERATIONS6 6.4% to 12.8%7 More than 12.8%99 Not known or not detectableNote: Signal strength of 10 or higher is needed for successful packet da

BASIC OPERATIONSCreating a Windows Dial-Up ConnectionEach version of the Windows operating system has different steps for creating dial-up Internet co

BASIC OPERATIONSEnter: MResponse: MUEnter: DResponse: MEnter: SResponse: S<cr><if><OK<cr><if>RecoveryTo do this manually:1.

REGULATORY STATEMENTSRegulatory StatementsEMC, Safety, and R&TTE Directive ComplianceThe CE mark is affixed to this product to confirm compliance

REGULATORY STATEMENTSThis device complies with Industry Canada RSS Appliance radio exempt from licensing. The operation is permittedfor the following

ENVIRONMENTAL NOTICESEnvironmental NoticesWaste Electrical and Electronic Equipment StatementWEEE DirectiveThe WEEE Directive places an obligation on

CONTENTSSetting the Access Point Number (APN) in Modem's Properties ...

ENVIRONMENTAL NOTICESREACH StatementRegistration of SubstancesAfter careful review of the legislation and specifically the definition of an “article”

ENVIRONMENTAL NOTICESRestriction of the Use of Hazardous Substances (RoHS)Multi-Tech Systems, IncCertificate of Compliance2011/65/EUMulti-Tech Systems

ENVIRONMENTAL NOTICESInformation on HS/TS Substances According to Chinese StandardsIn accordance with China's Administrative Measures on the Cont

ENVIRONMENTAL NOTICESInformation on HS/TS Substances According to Chinese Standards (inChinese)依依照照中中国国标标准准的的有有毒毒有有害害物物质质信信息息根据中华人民共和国信息产业部 (MII) 制定的电

INDEXIndexA EAccess Point Number ...44 45 EGSMaccount activation...

INDEXL PTCRB ...31LED ...

INDEXUSB cable ...40 Vuser responsibility ...

PRODUCT OVERVIEWProduct OverviewOverviewMultiModem iCell modems provide wireless data communications and integrate seamlessly with otherapplications.

PRODUCT OVERVIEWPackage ContentsNote: For HSPA+, EDGE, and GPRS devices, your wireless provider supplies the SIM card. Other models do notuse SIM card

SAFETY NOTICES AND WARNINGSSafety Notices and WarningsGeneral SafetyThe modem is designed for and intended to be used in fixed and mobile applications

SAFETY NOTICES AND WARNINGS Lors de l'installation de l'équipement dans un bâti, veillez à ce que la charge mécanique soit homogène desorte