Multitech ISI608PC Bedienungshandbuch PDF herunterladen (Seite 21)

3 - ISI608 Driver Installation

Novell NetWare Connect AIO Driver Installation

Multi-Tech Systems provides “AIO” drivers for the ISI608, so

that it can function with Novell compatible asynchronous

applications (i.e., NetWare Connect). The drivers need to be

loaded on the file server in which the board(s) is/are installed.

The drivers can be loaded from the file server’s console

prompt or they can be incorporated, for autoloading, in the

AUTOEXEC.NCF file. The AIO driver is simply an NLM

(NetWare Loadable Module) which runs on the file server.

To install the Multi-Tech AIO driver, copy the file

“AIOISIX.NLM”

to the system directory of the file server from a

workstation on the network. For example, you may use the

following command to do the copy:

COPY A:\AIOISIX.NLM F:\SYSTEM

To load the AIO driver, go to the system or PC (in which the

ISI608 resides) console and at the prompt (:) type:

LOAD AIOISIX [port=W] [int=X] [name=Y] [node=Z]

where

W is the hexadecimal I/O port address for the ISI608. The

ISI608 occupies the next 15 I/O addresses on the bus. That

is, if you specify the address 100 hex, then the ISI608 will

occupy the addresses from 100 hex to 10F hex (total of 16

addresses).

X is the interrupt (IRQ) vector number for the ISI608. The

ISI608 can be set for IRQ vectors 2, 3, 4, 5, 7, 10, 11, 12 & 15.

Y sets the ISI608 board name.

Z overrides the default node ID number for the ISI608.

Note that all these parameters are optional. In a case where

none of them are supplied, the ISI608 AIO driver will assume

the default I/O address and IRQ values and try to load the

driver.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 80 81

Keine Kommentare

Multitech ISI608PC Bedienungshandbuch Seite 21