Multitech MT5600BA Betriebsanweisung PDF herunterladen (Seite 24)

Chapter 3 – Using the Front Panel

Multi-Tech Systems, Inc. MT5600BA-V92 User Guide 24

CALLBACK SECURITY

Use  and Enter to turn callback security on or off. Same as the #DB0 and

#DB1 commands. For more information about callback security, see Chapter

6, “Callback Security.”

PASSWORD SETUP

Use to enter callback security passwords in

memory locations 1–30. Each password must

be six to ten characters in length. To scroll

through a list of digits and characters, press 

 and . To go to the next position, press .

To back up or to exit without saving, press 

several times. To save the password, press

Enter. Same as the #CBP= command.

CALLBACK NUMBER

Use to enter callback security phone numbers

in memory locations 1–30. Each number can be

up to 30 characters long. Same as the #CBN=

command. Note: Only 16 characters can be

displayed at a time. To see characters 17–30,

press the  button. To go to the previous LCD,

press the  button. To go to the next LCD,

press the  button.

S-REGISTER OPTIONS

Use , , and Enter to display the current S-register values and enter new

values. Same as the Sr? and Sr=n commands.

VIEW S-REGISTER

SETTINGS

Use     and Enter to select the

number of the S-register whose value you want

displayed. To scroll through a list of digits, press

 and . To go to the next position, press

. To back up or to exit without saving, press

 several times. To display the value, press

Enter. Same as the Sr? command.

SET S-REGISTER

Use     and Enter to select the

number of the S-register whose value you want

to change, and the value you want to enter. To

scroll through a list of digits, press  and .

To go to the next position, press . To back up

or to exit without saving, press  several

times. Same as the Sr=n command.

MONITOR OPTIONS

Use   and Enter to display line quality and the line signal-to-noise ratio.

LINE QUALITY

Use  and Enter to display line signal quality as

a three-digit number. The higher order byte of

the EQM value is displayed. Based on the EQM

value, retrain or fallback/fall forward may be

initiated if enabled by %E1 or %E2. Same as the

%Q command.

SIGNAL TO NOISE RATIO

Use  and Enter to display the line signal-to-

noise ratio in dB.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 56 57

Kommentare zu diesen Handbüchern

Keine Kommentare

Multitech MT5600BA Betriebsanweisung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Modems Multitech MT5600BA