Multitech RF825-E-AP Betriebsanweisung Seite 31
- Seite / 104
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 4 – Configuring the RouteFinder
Multi-Tech Systems, Inc. RouteFinder RF825/RF825-AP User Guide (Document Number S000422B) 31
Configuring the RouteFinder Using the Wizard Setup
• WAN PPPoE Choice
PPPoE (Point-to-Point over Ethernet) is a specification for connecting multiple
computer users on an Ethernet local area network to a remote site through DSL or
cable modems or wireless connection to the Internet. The following fields display
when you select PPPoE:
User Name
Enter the user name give by the ISP.
Example: user1@xyz.com
or user 1
Password
Enter the user’s password.
These characters are not allowed: <, >.
The maximum number of allowed is 18.
Retype Password
Retype the password to confirm the one entered above. Passwords must
match in order to continue. If you receive an error, enter password in both
fields again.
Idle Time
This option is available only when the Connection Type is Trigger on
Demand. Specify the inactivity time (in seconds) after which the PPPoE link
should be brought down.
Connection Type
Specify the type of connection for the link. Options are:
Always Connect: The link will always be established. It is not dependent on
whether or not there is data or a traffic flow through the RouteFinder. Default.
Trigger on Demand: The link will be established only when there is data or a
traffic flow through the RouteFinder.
Dynamic IP Address from ISP
Check the box to Enable the Dynamic IP address to be provided by the ISP. If
enabled, the IP address obtained from the ISP is dynamic. If disabled, enter
the IP address and subnet mask from the ISP in the following Fixed Address
fields: IP Address and Net Mask
Note: If the ISP does not support the Fixed Address option, then the
RouteFinder will accept the dynamic IP address provided by the ISP.
Accept DNS Address from Peer
Check this box if you want the DNS server address to be obtained from the
peer (the ISP). The DNS address obtained from the ISP will be displayed on
the Network Setup > Interface screen. The details of the address/subnet mask
obtained from the ISP are displayed as the Present Status on this screen.
- RouteFinder 1
- Contents 3
- Chapter 1 – Introduction and 6
- Product Description 6
- Feature Details 7
- RouteFinder Documentation 8
- Safety Warnings 9
- Front and Back Panels 10
- Signal Strength AT Commands: 11
- Definition of xx Values 11
- CDMA & EDGE Back Panel 12
- Back Panel Connectors 12
- Application Example 13
- RF825-AP Specifications 14
- EDGE Specifications 15
- CDMA Specifications 15
- Specifications Description 16
- Chapter 2 – Cabling the 17
- RF825-AP Cabling 18
- Chapter 3 – Setting Up a 19
- Workstation and a Wireless 19
- Account 19
- Setting a Fixed IP Address 20
- Provider’s Service 21
- Command Examples 24
- Chapter 4 – Configuring the 25
- Navigating the Screens 26
- Sub-Menus 27
- Wizard 28
- The Wizard Setup Screen 29
- ISP Settings 30
- • WAN PPPoE Choice 31
- Admin Password 32
- Save, Reset 32
- Save to Flash Memory 33
- Restart 33
- Testing Your Workstation 33
- Web Management Software 34
- Auto Reboot Timer 35
- Administrative Access 36
- Change Password 37
- Remote Syslog 38
- SNTP Configuration 39
- Administration > Tools 41
- Trace Route 42
- DDNS – WAN 42
- Reset Modem 42
- Reset to Factory Defaults 42
- Networks & Services 43
- Network Configuration Fields 44
- How to Confirm Your Entries 44
- Important Network Notes: 44
- Service Configuration Screen 45
- Service Configuration 46
- Notes About Protocols 46
- Network Setup 47
- WAN Choice: Static IP 48
- WAN Choice: PPPoE 49
- WLAN Settings 50
- WLAN Security 51
- This is the WAP-PSK screen 52
- This is the WPA2-PSK screen 52
- Modem Initialization Strings 57
- PPP Keep-Alive Parameters 57
- PPP/Internet Keep-Alive URLs 57
- Network Setup > SNAT 61
- Network Setup > DNAT 62
- Packet Filters 63
- Packet Filter > ICMP 66
- VPN > IPSec 67
- Add an IKE Connection 68
- Add IKE Connection 68
- Add a Manual Connection 70
- Add Manual Connection 70
- VPN > PPTP 72
- User Authentication 73
- Proxy > HTTP Proxy 74
- Proxy > Custom Filters 75
- Proxy > DNS Proxy 76
- DHCP Server 77
- Fixed Addresses 78
- Utilities 79
- Statistics & Logs 80
- Chapter 6 – Troubleshooting 85
- CDMA Troubleshooting 87
- EDGE Troubleshooting 87
- Chapter 7 – Frequently Asked 88
- Questions 88
- EDGE FAQs 90
- CDMA FAQs 90
- Supported Subnet Addresses 91
- Appendix B – Antenna for the 93
- Wireless RouteFinder 93
- The Wireless Antenna 94
- Glossary 96
Verwandte Produkte und Handbücher für Gateways / Controller Multitech RF825-E-AP
(8 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern